|
Corrosion Control and Environmental Protection
for Your Tank.
With the high cost of tanks, it makes sense to
spend a few more dollars to protect your
investment. The Bottom Saver stops corrosion by
breaking the electric currents needed for
corrosion to take place. You also get the piece
of mind that a pinhole leak in the tank cannot
go undetected. The built-in sump (optional)
allows you to clean the tank without putting
fluids on the ground. The Bottom Saver is fully
reusable and guaranteed for the life of the tank
against chemical and ultraviolet attack.
The Bottom Saver is a High Density Polyethylene
(HDPE) tank pad specially designed to:
-
Remove corrosion-causing moisture from the tank
bottom.
-
Extends the life of new and used tanks.
-
Create absolute assurance that no pinhole leaks
are seeping into the ground.
-
Keep bottom sediments off the ground during
routine tank cleaning.
-
Protects the earth under the tank.
-
Be affordable .
Installation is
simple, just unroll the Bottom Saver and place in the desired
location. Then dig a small hole for the sump
(sump optional). Place the tank on the Bottom
Saver, positioning the clean-out manway in the
sump. The tank can be slid into proper alignment
without damaging the Bottom Saver as long as the
clean-out manway remains in the sump. Two men
can install a Bottom Saver in about 10 minutes.
The Bottom Saver can be expanded into a complete
secondary containment lining system. This can be
done at any time, even years later without
lifting the tank.
In today's world, can you afford not to protect
your tank bottom or possibly more importantly the earth under it?
What ever your
containment needs are, contact an All Tech Insulation Engineer today
(989-826-9999) and let us
take the time to understand
your specific
containment
requirements so
that we may provide you a
free quote on a
system that delivers results.
|
